Sensor, Knock: Installation: 6.2L
WARNING: This page is about a different car, the 2019 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Over or under tightening the knock sensor mounting bolts will affect knock sensor performance, possibly causing improper spark control.
- Install the knock sensor (1) onto the cylinder block.
- Tighten the bolt (2) to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Connect the knock sensor wire harness connector (5).
- Snap the heat shield (1) onto the knock sensor.
- Install the front skid plate. Refer to PLATE, SKID, TRANSFER CASE, INSTALLATION .
- Connect the negative battery cable.