Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2020 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Starting System (Service Information)) >> Relay, Power Control >> Installation

Relay, Power Control: Installation

WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0175256Courtesy of CHRYSLER GROUP, LLC
  1. Using two nuts, install the Power Control Relay (2) to the PCR bracket (1).
    GC0175214Courtesy of CHRYSLER GROUP, LLC
  2. Connect and secure the eyelet terminals (1) to the PCR using two nuts (3).
  3. Connect the wire harness connector (2) to the PCR.
    GC0175247Courtesy of CHRYSLER GROUP, LLC
  4. Inster the PCR cover (1) to the PCR.
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About Mike's Workshop Manuals