Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2020 >> Grand Cherokee Laredo, AWD, Automatic T/Case Control >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Fuel System) >> Fuel Injection, Gas >> Sensor, TMAP-Intake Manifold >> Removal >> Bank 1

Bank 1

WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0170121Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the left side engine cover (1).
    GC0170459Courtesy of CHRYSLER GROUP, LLC
  3. Clean the area around the Temperature and Manifold Absolute Pressure (TMAP) sensor (3).
  4. Disconnect the TMAP sensor wire harness connector (2).
  5. Remove the screw (1) and the TMAP sensor (3).
scientia non olet · About Mike's Workshop Manuals