Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2020 >> Gladiator Altitude, Automatic Trans >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension & Wheel Alignment >> Front >> Arm, Upper Control >> Removal And Installation >> Removal

Removal And Installation: Removal

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    NOTE:

    If the vehicle is equipped with a cam bolt service kit, paint or scribe marks on the cam adjuster and the control arm for installation reference.

  2. Using a suitable stand support the front axle assembly.
    GC0182911Courtesy of CHRYSLER GROUP, LLC
  3. Remove the upper control arm front nut and the upper control arm front bolt (1).
    GC0192876Courtesy of CHRYSLER GROUP, LLC
  4. Remove the two heat shield bolts (1) and remove the heat shield (2).
    GC0192976Courtesy of CHRYSLER GROUP, LLC
  5. Remove the upper control arm rear bolt (1) and retain the flag nut to be reused.
  6. Remove the upper control arm (2).
scientia non olet · About Mike's Workshop Manuals