Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2020 >> Compass Trailhawk >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Sensor, Exhaust Temperature >> Removal And Installation >> Exhaust Gas Temperature Sensor 1/1 - 2.0L >> Installation

Exhaust Gas Temperature Sensor 1/1 - 2.0L: Installation

GC0163001Courtesy of CHRYSLER GROUP, LLC
  1. Install the Exhaust Gas Temperature (EGT) sensor and tighten the fitting (1) to the proper specification Refer to TECHNICAL SPECIFICATIONS .
  2. Connect the EGT sensor wire harness connector.
  3. Install the radiator. Refer to RADIATOR, ENGINE COOLING, REMOVAL AND INSTALLATION .
  4. Install the radiator cooling fan. Refer to FAN, COOLING, REMOVAL AND INSTALLATION .
  5. Install the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION .
  6. Evacuate and charge the A/C system. Refer to PLUMBING, STANDARD PROCEDURE .
  7. Fill the cooling system. Refer to STANDARD PROCEDURE .
  8. Install the belly pan. Refer to BELLY PAN, REMOVAL AND INSTALLATION .
  9. Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
  10. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals