Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2019 >> Wrangler Unlimited Moab >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Intrusion Transceiver (ITM) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbags, airbag curtains, knee blocker, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect the Intelligent Battery Sensor (IBS)/negative battery cable assembly from the negative battery post, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

  1. Disconnect and isolate the negative battery cable(s). Refer to STANDARD PROCEDURE .
  2. Move the driver seat to the furthest rear position.
    GC0182442Courtesy of CHRYSLER GROUP, LLC
  3. Reach under the dash on drivers side and remove the fasteners (1) from the Intrusion Transceiver Module (ITM).
  4. Remove the wire harness connector from the ITM.
  5. Remove the ITM from the vehicle.
scientia non olet · About Mike's Workshop Manuals