Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2019 >> Wrangler Unlimited Moab >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Drivetrain Control (DTCM) >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Position the DTCM in the mounting bracket.
  2. Slide the DTCM into place until the locking tabs are secure.
  3. Connect the body wire harness connector to the DTCM.
  4. Install the right rear quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable(s). Refer to STANDARD PROCEDURE .
  6. If replacing the DTCM, the transfer case, or both, use the scan tool to perform the Non-Volatile Memory Reset procedure.
  7. Perform the DTCM verification test. Refer to DTCM VERIFICATION TEST .
scientia non olet · About Mike's Workshop Manuals