Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE:
Illustration shown with instrument panel removed from view for clarity.
- Disconnect and isolate the negative battery cable(s) (Refer to NEGATIVE CABLE .
- Remove the left front floor air outlet. Refer to OUTLET, AIR, REMOVAL AND INSTALLATION
.
- Disconnect the wire harness connectors (1a) from the Heating, Ventilation, and Air Conditioning (HVAC) module (1b).
- Remove the two screws (1a) that secures the HVAC module (2) to the housing.
- Remove the HVAC module (2).