Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2019 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 924 (Electronic Control Modules (Service Information)) >> Module, Park Assist (PAM) >> Removal

Module, Park Assist (PAM): Removal

WARNING: This page is about a different car, the 2018 Fiat 500L. However, it is still accessible from the selected car via links, so may be relevant.
GC0158584Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery.
  2. Remove the trim from the left quarter inner panel to access the Park Assist Module (PAM) (1) located between the C-pillar and the D-pillar. Refer to PANEL, QUARTER TRIM, REAR, REMOVAL .
  3. Disconnect the two body wire harness connectors (3) from the PAM connector receptacles.
  4. Using a drill motor and an appropriate bit, carefully drill out the two blind rivets (2) that secure the PAM to the left quarter inner panel.
  5. Remove the PAM from the vehicle.
scientia non olet · About Mike's Workshop Manuals