Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2019 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 1308 (Electronic Control Modules (Service Information)) >> Module, Fuel Pump Control >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that the FPCM is not damaged.
  2. Install the FPCM and securely tighten the fasteners.
  3. Connect the wire harness connector to the FPCM connector receptacle.
  4. Install the left rear splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an IBS, connect the IBS connector.
  6. Remove the support and lower the vehicle.
scientia non olet · About Mike's Workshop Manuals