Box, MOPAR Connect TELEMATIC - LHD

Courtesy of CHRYSLER GROUP, LLC

Before installation, make a note of the data on the label at of the control module. This data will be needed for the test procedure at the end of the installation.

Courtesy of CHRYSLER GROUP, LLC
Apply a strip of bi-adhesive Velcro to the back of the T-box module.

Courtesy of CHRYSLER GROUP, LLC
Apply the Coroplast covering tape to the parts of the T-box module in contact with the vehicle to prevent vibration noise when it is mounted on the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Inspect the T-box wiring for Coroplast tape (2) covering up to the electrical connector. Add Coroplast tape as needed.

Courtesy of CHRYSLER GROUP, LLC
Clean the contact surface (1) with isopropyl alcohol or heptane where the module will be fitted.

Courtesy of CHRYSLER GROUP, LLC
Position the control module (1a) on the bracket with the connector socket facing upwards, and secure it with double-sided adhesive tape and two cable ties (1b). Pass the cable ties through the slots in the bracket.

Courtesy of CHRYSLER GROUP, LLC
Connect the wiring connector (1a) to the control module (1b).
Install the glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
On completion of installation of the T-box module, connect the diagnosis instrument to the car's OBD II socket, locate the BCM module and check for errors.