Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2019 >> Grand Cherokee Laredo, AWD, Automatic T/Case Control >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Ignition System (Service Information)) >> Sensor, Knock >> Installation >> 6.2L

Sensor, Knock: Installation: 6.2L

WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0080083Courtesy of CHRYSLER GROUP, LLC
CAUTION:

Over or under tightening the knock sensor mounting bolts will affect knock sensor performance, possibly causing improper spark control.

  1. Install the knock sensor (1) onto the cylinder block.
  2. Tighten the bolt (2) to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
  3. Connect the knock sensor wire harness connector (5).
    GC0080084Courtesy of CHRYSLER GROUP, LLC
  4. Snap the heat shield (1) onto the knock sensor.
  5. Install the front skid plate. Refer to INSTALLATION .
  6. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals