Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2019 >> Grand Cherokee Laredo, AWD, Automatic T/Case Control >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Cooling System) >> Engine >> Sensor, Coolant Temperature >> Installation >> 3.0L Diesel

3.0L Diesel

WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0172149Courtesy of CHRYSLER GROUP, LLC
  1. Install the coolant temperature sensor (1) into water pump housing and torque to 11 N.m (8 ft. lbs.).
    GC0158079Courtesy of CHRYSLER GROUP, LLC
  2. Connect the coolant temperature sensor wire harness connector (1).
  3. Fill the cooling system. Refer to STANDARD PROCEDURE .
    GC0146436Courtesy of CHRYSLER GROUP, LLC
  4. Install the engine cover (1).
  5. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals