Sensor, Air Temperature, Intake: Installation: 3.6L
WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- The sensor O-ring seal can be reused if not damaged.
- Clean the Inlet Air Temperature (IAT) sensor mounting hole in the air inlet hose.
- Install the IAT sensor (1) into the air inlet hose and rotate clockwise until the release tab engages.
- Install the IAT sensor wire harness connector (1).
- Install the engine cover. Refer to INSTALLATION .
- Connect the negative battery cable.