Sensor, Air Temperature, Intake: Installation: 1.4L
WARNING: This page is about a different car, the 2018 Fiat 500L. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This sensor monitors both Inlet Air Temperature (IAT) and Manifold Air Pressure (MAP).
- The IAT/MAP sensor O-ring (1) can be reused if not damaged.
- Apply a small amount of engine oil to the sensor O-ring (1).
- Install the IAT/MAP sensor (1) into the intake manifold with the bolt (2) tightened to 9 N.m (80 in. lbs.).
- Connect and lock the wire harness connector (3) to the sensor.
- Install the air cleaner body (1). Refer to BODY, AIR CLEANER, INSTALLATION .
- Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).