Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2018 >> Grand Cherokee Trackhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 400 (Electronic Control Modules (Service Information)) >> Module, Electronic Limited Slip Differential >> Removal >> Removal

Module, Electronic Limited Slip Differential: Removal: Removal

WARNING: This page is about a different car, the 2016 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electronic Limited Slip Differential Module & Connectors
GC0146895Courtesy of CHRYSLER GROUP, LLC
  1. Remove left rear seat. Refer to SEAT, REAR, REMOVAL .
  2. Disconnect and isolate the negative battery cable. Refer to CABLES, BATTERY, REMOVAL for battery location and disconnect procedure.
  3. Pull carpet back to expose ELSD module (1).
  4. Disconnect the body wire harness connectors (3) from the module connector receptacle.
  5. Remove module mounting nuts (2).
  6. Remove the module from the vehicle.
scientia non olet · About Mike's Workshop Manuals