Section 363 (Starting System (Service Information)): Operation: Starting: Start/Stop
WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
The START/STOP feature operation works in part like a non-START/STOP system.
For the engine to "AUTO-STOP" the vehicle must meet the following conditions:
- Vehicle speed < 4.5KPH (2.8 MPH)
- Engine coolant temperature between 20°C (68°F) and 115°C (239°F)
- Battery state acceptable
- Brake vacuum acceptable
- Ambient temperature and pressure acceptable
- HVAC high demand not present
- Hood not open
- T-case not low-range
- DPF regeneration not active
- Stop/start functionality not turned off
- Driver seat belt latched
- Starter overheat protection not active
- System fault not present (critical or non-critical)
For the engine to "AUTO-START" the vehicle must meet the following conditions:
- Vehicle speed > 5 KPH (3 MPH)
- Engine coolant temperature between 20°C (68°F) and 115°C (239°F)
- Accelerator pedal not pressed
- Battery state acceptable
- HVAC high demand not present
- Hood not open
- T-case not low-range
- DPF regeneration not active
- Driver seat belt latched
- Starter overheat protection not active
- System fault not present (critical or non-critical)