Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2018 >> Compass Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Electronic Control Modules (Service Information) - Mp) >> Module, Trailer Tow (TTM) >> Removal And Installation >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the TTM on to the mounting bracket and install the four mounting bolts and tighten securely.
  2. Position the TTM in the vehicle.
  3. Connect the two TTM wire harness connectors.
  4. Engage the retaining clip securing the TTM to the body.
  5. Install the left rear storage tub.
  6. Connect the negative battery cable.
  7. If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.
scientia non olet · About Mike's Workshop Manuals