Box, MOPAR Connect TELEMATIC: Installation

WARNING: This page is about a different car, the 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Apply a strip of biadhesive Velcro to the back of the T-Box module.

Courtesy of CHRYSLER GROUP, LLC
Apply the Coroplast covering tape to the parts of the T-Box module in contact with the vehicle to prevent vibration noise when it is mounted on the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Insert the T-Box (1), already connected to its harness, inside the dashboard, while keeping it vertical.

Courtesy of CHRYSLER GROUP, LLC
Position the T-Box (1) on the internal dashboard bracket and turn it to the horizontal position with the wiring facing downwards.

Courtesy of CHRYSLER GROUP, LLC
Fix the T-Box in position using the bands (1) provided.
NOTE:
Take care to position the bands so that they do not also pass over the innermost metal bracket.
Install the lower B pillar trim. Refer to PANEL, B-PILLAR TRIM, LOWER, REMOVAL AND INSTALLATION and PANEL, B-PILLAR TRIM, UPPER, REMOVAL AND INSTALLATION .
Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
On completion of installation of the T-Box module, connect the diagnosis instrument to the car's EOBD socket, locate the BCM module and check for errors.