Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2018 >> Cherokee Overland, 3.2L Eng VIN X, AWD, Automatic T/Case Control >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Cooling System >> Engine >> Sensor, Coolant Temperature >> Removal >> 2.2L Diesel

2.2L Diesel

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the engine cover. .
  3. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  4. Drain the cooling system. Refer to STANDARD PROCEDURE .
    GC0162262Courtesy of CHRYSLER GROUP, LLC
  5. Remove the clip and the Engine Cooling Temperature (ECT) sensor (1) from the thermostat housing.
    GC0162349Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the (ECT) sensor wire harness connector (1).
scientia non olet · About Mike's Workshop Manuals