Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2018 >> Cherokee Latitude Plus, 3.2L Eng VIN X, AWD, Automatic T/Case Control >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Radio Frequency (RF Hub) >> Removal

Module, Radio Frequency (RF Hub): Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Pull down the rear of the headliner to gain access to the Radio Frequency Hub (RF-Hub) module. Refer to HEADLINER, REMOVAL .
  3. Disconnect both body wire harness connectors (1) (if equipped) and the antenna wire harness connector (2) (if equipped) from the RF-Hub.
    GC0176934Courtesy of CHRYSLER GROUP, LLC
  4. Remove both fasteners (1) securing the RF-Hub module to the vehicle.
  5. Remove the RF-Hub module.
scientia non olet · About Mike's Workshop Manuals