Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Engine Cooling System) >> Engine >> Sensor, Coolant Temperature >> Installation >> 2.0L Diesel

2.0L Diesel

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0159853Courtesy of CHRYSLER GROUP, LLC
  1. Install the Engine Cooling Temperature (ECT) sensor (2) to cylinder head and tighten to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
  2. Connect the ECT sensor wire harness connector (1).
  3. Install the engine cover. Refer to the appropriate service information article.
  4. Replace any lost engine coolant. Refer to STANDARD PROCEDURE .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About Mike's Workshop Manuals