Removal - Power Distribution Z-Case Fuse Array

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

For complete circuit diagrams, refer to the appropriate wiring information. The wiring information includes wiring diagrams, further details on wire harness routing and retention, as well as pin-out and location views for the various wire harness connectors, splices and grounds.

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the cover from the Power Distribution Center (PDC).
Remove the screws (2) from Z case fuse array and move the eyelet connectors off and away from the Z case fuse array.
Remove the screw (1) attaching the fuse array to the PDC.
Press on the tabs (3) on the side of the fuse array to separate the array from the PDC.
Lift the fuse array away from the PDC.