Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2017 >> Wrangler Rubicon, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Power Distribution) >> Center, Power Distribution (PDC) >> Installation >> Installation - PDC Assembly

Installation - PDC Assembly

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0159190Courtesy of CHRYSLER GROUP, LLC
  1. Position the upper PDC tray to the PDC base (3) in the engine compartment.
  2. Connect the three bulkhead connectors (2) located in the base of the PDC to the upper PDC tray bottom.
    GC0159652Courtesy of CHRYSLER GROUP, LLC
  3. Tighten three screws (2) through the upper PDC tray to 5 N.m (44 In. Lbs.).
  4. Connect all power feeds to their proper PDC posts.
  5. Install the PDC cover onto the PDC assembly.
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About Mike's Workshop Manuals