Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2017 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 ((Drivetrain Control Module (DTCM) - Electrical Diagnostics)) >> DTC Troubleshooting >> C2270-77-EDA Hall Sensor - Commanded Position Not Reachable >> When Monitored And Set Conditions

When Monitored And Set Conditions

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
Possible Causes
DRIVETRAIN CONTROL MODULE (DTCM) WIRE HARNESS
REAR PROPELLER SHAFT MOTOR
DRIVETRAIN CONTROL MODULE (DTCM)
REAR DRIVELINE MODULE (RDM)

Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to  PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE  . 

scientia non olet · About Mike's Workshop Manuals