Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2017 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Ignition System (Service Information)) >> Solenoid, Variable Valve Timing >> Installation >> Left

Solenoid, Variable Valve Timing: Installation: Left

WARNING: This page is about a different car, the 2017 RAM ProMaster 3500, 2017 RAM ProMaster 2500, and 2017 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.
GC0144209Courtesy of CHRYSLER GROUP, LLC
  1. Install the Variable Valve Timing (VVT) solenoid seals (1). The seals can be reused if not damaged.
    GC0144208Courtesy of CHRYSLER GROUP, LLC
  2. Refer to the markings made at disassembly and install the intake VVT solenoid (4) and the exhaust variable valve timing solenoid (2) in their original locations.
  3. Install the VVT solenoid mounting bolts (3) and hand tighten.
  4. Connect the wiring harness connector (1) to the VVT solenoid.
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:

The Cam/Crank Variation Relearn procedure must be performed using the scan tool anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valvetrain, camshaft and/or crankshaft sensors or components.

scientia non olet · About Mike's Workshop Manuals