Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2017 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 ((Active Cruise Control (Acc) Module - Electrical Diagnostics)) >> Standard Procedure >> Adaptive Cruise Control Verification Test >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

ADAPTIVE CRUISE CONTROL VERIFICATION TEST 

  1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
  2. With the scan tool, erase Adaptive Cruise Control (ACC) DTCs.
  3. Make sure that all accessories are turned off and that the battery is fully charged.
  4. If the ACC Module was replaced or moved in any way, the ACC Module must be aligned. Perform the Sensor Vertical Alignment procedure. Refer to MODULE, ADAPTIVE CRUISE CONTROL, MODULE PROGRAMMING .
  5. Test drive the vehicle and verify proper operation.
  6. With the scan tool, read ACC DTCs.

    Are there any DTCs present in the ACC module?

    Yes 

    No 

    • Repair is complete.
scientia non olet · About Mike's Workshop Manuals