Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2017 >> Renegade Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Electronic Control Modules (Service Information)) >> Module, Park Assist >> Removal And Installation >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Left Inner Quarter Panel, Supplemental Junction Box & Nuts
GC0169094Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
  2. Remove the trim from the left inner quarter panel (1) to access the Park Assist Module (PAM) behind the left rear wheel house. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  3. Remove the two nuts (2a) that secure the supplemental Junction Box (JB) (2b) and move the JB aside.
    Fig 2: Park Assist Module, Push-Pin Retainers & Connectors
    GC0168984Courtesy of CHRYSLER GROUP, LLC
  4. Remove the two plastic push-pin retainers (1a) that secure the PAM (1b).
  5. Disconnect the two or three wire harness connectors (2a and 2b) from the PAM connector receptacles.
  6. Remove the PAM (3) from the vehicle.
scientia non olet · About Mike's Workshop Manuals