Sending Unit And Sensor, Fuel Level: Installation

Courtesy of CHRYSLER GROUP, LLC

1 - WIRING GROOVE

1. Wrap wires into groove in back of level sensor.
2. While feeding wires into guide grooves (1).

   Courtesy of CHRYSLER GROUP, LLC

   1 - FUEL LEVER SENSOR

3. Slide level sensor up into channel until it snaps into place. Ensure tab at bottom of sensor locks in place.
4. Install wire into wire retainer.

   Courtesy of CHRYSLER GROUP, LLC

5. Install level sensor wires in connector. Push the wires up through the connector and then pull them down until they lock in place. Ensure signal and ground wires are installed in the correct position .
6. Install locking wedge on connector.

   Courtesy of CHRYSLER GROUP, LLC

   1 - ELECTRICAL CONNECTOR

7. Push connector up into bottom of fuel pump module electrical connector (1).
8. Install fuel pump module. Refer to MODULE, FUEL PUMP, INSTALLATION  .