Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2017 >> Cherokee Trailhawk, 3.2L Eng VIN S >> Repair and Diagnosis >> Body & Frame >> Windows >> Power Windows (Service Information) >> Motor, Window Regulator >> Installation

Motor, Window Regulator: Installation

GC0147660Courtesy of CHRYSLER GROUP, LLC
NOTE:

The power window motor may need to actuated momentarily to line up the gear in the drive assembly with the regulator.

  1. Connect the power window motor electrical connector to the motor electrical connector receptacle (3).
  2. Position the power window motor and gear assembly (2) on the carrier plate (1) aligning the drive gear with the regulator.
  3. If necessary, temporarily connect the window switch assembly and battery to actuate the motor.
  4. Install and tighten the three fasteners (4) that secure the power window motor and gear assembly to the carrier plate.
    GC0145458Courtesy of CHRYSLER GROUP, LLC
  5. Reinstall the door interior trim panel (2), for front panel refer to PANEL, DOOR TRIM, INSTALLATION For rear panel refer to PANEL, REAR DOOR TRIM, INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About Mike's Workshop Manuals