Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2017 >> Cherokee Trailhawk, 3.2L Eng VIN S >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Drivetrain Control (DTCM) >> Removal

Module, Drivetrain Control (DTCM): Removal

  1. Open the liftgate.
  2. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  3. Remove the cargo load floor. Refer to LOAD FLOOR, CARGO, REMOVAL .
    GC0159573Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the Drivetrain Control Module (DTCM) wire harness connectors.
  5. Remove the two nuts (1) holding the DTCM in place.
  6. Remove the DTCM.
scientia non olet · About Mike's Workshop Manuals