Module, Drivetrain Control (DTCM): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Install the Drivetrain Control Module (DTCM) (2) to the mounting studs.
2. Install the DTCM mounting nuts (1) and tighten to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
3. Connect the DTCM wire harness connectors.
4. Install the cargo load floor. Refer to LOAD FLOOR, CARGO, INSTALLATION .
5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
6. Perform the DTCM verification test. Refer to DTCM VERIFICATION TEST .