Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2015 >> Compass Limited, FWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (3.7L Engine (Service Information)) >> Engine Mounting >> INSULATOR, Engine Mount, Front >> Installation >> Installation

INSULATOR, Engine Mount, Front: Installation: Installation

WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the insulator mount and install the insulator mount through bolt.
  2. Lower the engine until the cylinder block-to-insulator mount bolts can be installed.
  3. Remove the jack and block of wood.
  4. Tighten the cylinder block-to-insulator mount bolts to 61 N.m (45 ft. lbs.).
  5. Install and tighten the through bolt retaining nut to 61 N.m (45 ft. lbs.).
  6. Install the fan blade, fan clutch and fan shroud.
scientia non olet · About Mike's Workshop Manuals