Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2014 >> Patriot Limited, AWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Fuel System) >> Fuel Injection, 2.8L Diesel >> Sensor, Air Temperature, Intake >> Installation >> Installation

Sensor, Air Temperature, Intake: Installation: Installation

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check condition of sensor O-ring and clean mounting.
  2. Lubricate sensor O-ring and sensor mounting hole with oil.
  3. Install the IAT/MAP sensor and securely tighten the bolt.
  4. Connect the IAT/MAP sensor harness connector.
  5. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals