Seal, Input Flange: Installation
WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
- Coat the edge face of the seal with the liquid gasket sealer.
- Install wave washer.
- Install the pinion seal using Installer (special tool #9931, Installer, Seal).
- Install the Electronically Controlled Clutch (ECC) onto the RDA.
- Install the mounting bolts (1) that hold the ECC to the RDA and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Plug in the electrical connector (3).
- Install the propeller shaft. Refer to INSTALLATION .
- Fill RDA as needed. Refer to SPECIFICATIONS .
- Lower vehicle and road test.