Auxiliary Fuel Pump Module

WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Risk of injury to eyes and skin from contact with fuel. Wear protective clothing and eye protection. Risk of poisoning from inhaling and swallowing fuel. Pour fuel only into appropriately marked and approved containers. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING:

The fuel system is under constant high pressure even with engine OFF. Until the fuel pressure has been properly released from the system, do not attempt to open the fuel system. Do not smoke or use open flames/sparks when servicing the fuel system. Make sure the area in which the vehicle is being serviced is in a well ventilated area. Failure to comply may result in serious or fatal injury.

NOTE:

It is necessary to remove the Main Fuel Pump and the Auxiliary Fuel Pump to remove and install the Fuel Pump Transfer tube.

Perform the fuel system pressure release procedure. Refer to the FUEL SYSTEM PRESSURE RELEASE PROCEDURE .
Disconnect and isolate the negative battery cable.
Remove the rear seat cushion cover. Refer to COVER, SEAT CUSHION, REAR, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the auxiliary fuel pump module access cover (1).
Disconnect the electrical connector (2) from the auxiliary fuel pump module.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
The auxiliary fuel pump module has to be properly located in the fuel tank for the fuel level gauge to work properly.
Mark the auxiliary fuel pump module orientation (1).

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Prior to removing the auxiliary fuel pump module, use compressed air to remove any accumulated dirt and debris from around fuel tank opening.
Position the Fuel Tank Module Wrench (special tool #10189, Wrench, DEF Module Lock Ring) into the notches on the outside edge of the lock-ring.
Install a 1/2 inch drive breaker bar into the Fuel Tank Module Wrench.
Rotate the breaker bar counterclockwise and remove the lock-ring.

Courtesy of CHRYSLER GROUP, LLC
Raise the auxiliary fuel pump module and disconnect the fuel transfer tube.
Remove the auxiliary fuel pump module from the fuel tank.

Courtesy of CHRYSLER GROUP, LLC
Remove and discard the rubber O-ring seal.

Courtesy of CHRYSLER GROUP, LLC
Pull the transfer tube (2) from the main fuel pump module opening. Inspect the tube and each quick connect (1) for twists, cracks, distorted portions, stress marks, split O-rings, proper function of the quick connects, etc.