Sending Unit And Sensor, Fuel Level: Removal
WARNING: This page is about a different car, the 2017 Jeep Patriot and 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
- Remove fuel pump module. Refer to MODULE, FUEL PUMP, REMOVAL .
- Depress retaining tab and remove the fuel pump/level sensor connector from the BOTTOM
of the fuel pump module wire harness connector.NOTE:
The pump module harness on TOP of flange is not serviceable or removable.
- Remove the wedge lock from the wire harness connector.
1 - TERMINAL REMOVAL TOOL 2 - FUEL LEVEL SENSOR CONNECTOR - Using the (special tool #C-4334, Extractor) tool (1) terminal remover or equivalent, remove terminals from level sensor harness connector (2).
1 - FUEL LEVER SENSOR - Remove wire from wire retainer.
- Depress the tab and unlock the sender card.
- Slide level sensor out of channel in module.