Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2014 >> Compass Limited, AWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Front Suspension & Wheel Alignment) >> Front >> Arm, Upper Control >> Installation >> Right Side

Right Side

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm to the vehicle.
  2. Install the upper control arm front flag bolt. With full vehicle weight  , tighten the nut to 122 N.m (90 ft.lbs.).
  3. Install the upper control arm rear flag bolt. With full vehicle weight  , tighten the nut to 122 N.m (90 ft.lbs.).
  4. Install the air box.
  5. Install the upper ball joint nut. Tighten the nut to 41 N.m (30 ft.lbs.) plus an additional 90° turn.
  6. Install the right side tire and wheel assembly. Refer to WHEELS, STANDARD PROCEDURE .
  7. Remove the supports and lower the vehicle.
  8. Set the toe. Refer to WHEEL ALIGNMENT, STANDARD PROCEDURE .
scientia non olet · About Mike's Workshop Manuals