Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2014 >> Compass Limited, AWD, Automatic Trans >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Driveline Module >> Input Flange Seal >> Removal >> Removal

Input Flange Seal: Removal: Removal

Fig 1: Electric Clutch At Rear Axle
GC0083879Courtesy of CHRYSLER GROUP, LLC
  1. Raise the vehicle on a hoist.
  2. Remove the propeller shaft. Refer to REMOVAL .
  3. Unplug the electrical connector (3) at the ECC.
  4. Disconnect ECC breather hose.
  5. Remove the ECC to RDA mounting bolts.
  6. Separate and lower ECC.
  7. Remove all old gasket material on the mating surfaces of the ECC and RDA. Remove wave washer
  8. Remove wave washer.
    Fig 2: Removing Input Flange Seal
    GC0083886Courtesy of CHRYSLER GROUP, LLC
  9. Remove the input flange seal.
scientia non olet · About Mike's Workshop Manuals