Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2014 >> Compass Limited, AWD, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System (Abs) - Electrical Diagnostics >> DTC Troubleshooting >> C1210-G Sensor Input Circuit Performance >> Diagnostic Test

Diagnostic Test

CHECK FOR A DTC C1210-G SENSOR INPUT CIRCUIT PERFORMANCE 

NOTE:

This DTC must be active for the results of this test to be valid.

  1. Turn the ignition on.
  2. With the scan tool, read and record DTCs.
  3. With the scan tool, read and record Freeze Frame information.
  4. With the scan tool, erase DTCs.
  5. Cycle the ignition switch from off to on.
  6. With the scan tool, read and record DTCs.

    Does the scan tool display: C1210-G SENSOR INPUT CIRCUIT PERFORMANCE?

    Yes 

    • Replace the Dynamics Sensor in accordance with the Service Information.
    • Perform ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .

    No 

    • The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
    • Perform ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About Mike's Workshop Manuals