Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2014 >> Compass Limited, AWD, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Vehicle Theft Security System (Service Information)) >> MODULE, Intrusion >> Removal >> Removal

MODULE, Intrusion: Removal: Removal

WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Intrusion Module
GC0085988Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Partially remove the trim from the inside of the left inner D-pillar (3). Refer to Body/Interior/PANEL, C-Pillar Trim - Removal .
  3. Disconnect the take out of the body wire harness (2) from the connector receptacle on the forward-facing side of the intrusion module (1).
  4. Remove the two plastic push-in fasteners (4) that secure the module to the inner D-pillar.
  5. Remove the module from the inner D-pillar.
scientia non olet · About Mike's Workshop Manuals