Motor, Window Regulator: Removal: Removal

Fig 1: Trim Panel

Courtesy of CHRYSLER GROUP, LLC

1. Partially raise or lower the door glass to relieve tension on motor and cables. Secure the glass as necessary.
2. Disconnect and isolate the negative battery cable.
3. Remove the door interior trim panel (1). Refer to DOOR - FRONT, FULL, PANEL, DOOR TRIM, REMOVAL , DOOR - FRONT, HALF, PANEL, DOOR TRIM, REMOVAL , DOORS - REAR, FULL, PANEL, REAR DOOR TRIM, REMOVAL or DOORS - REAR, HALF, PANEL, REAR DOOR TRIM, REMOVAL for the appropriate procedure.
   Fig 2: Identifying Motor Components

   Courtesy of CHRYSLER GROUP, LLC
4. Disconnect the power window motor electrical connector (2) from the motor electrical connector receptacle.
5. Remove the three fasteners (1) that secure the power window motor and gear assembly (3) to the carrier plate.
   Fig 3: Identifying Cable Drive And Motor

   Courtesy of CHRYSLER GROUP, LLC
6. Using a flat bladed tool, lightly pry the cable drive (1) away from the motor (2) and remove the motor and gear assembly.