Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2013 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Electronic Control Modules (Service Information)) >> Module, Radio Frequency (RF Hub) >> Removal >> Removal

Module, Radio Frequency (RF Hub): Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Electrical Connectors & Two Rear Push Pin Fasteners
GC0146128Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Partially remove the headliner to access the RF-Hub located at the center rear. Refer to HEADLINER, REMOVAL .
    Fig 2: Electrical Connectors, Retainers & RF Hub
    GC0147719Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the electrical connectors (1).
  4. If equipped, disconnect the remote start antenna connector.
  5. Remove the retainers (2) and remove the RF Hub (3) from the vehicle.
scientia non olet · About Mike's Workshop Manuals