Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2013 >> Grand Cherokee Laredo, AWD >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Sensor, Exhaust Temperature >> Removal >> Exhaust Temperature Sensor 1/2

Exhaust Temperature Sensor 1/2

Fig 1: Exhaust Temperature Sensor Connector
GC0146438Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Remove the transmission skid plate. Refer to PLATE, SKID, TRANSMISSION, REMOVAL .
  3. Disconnect the exhaust temperature sensor wire harness connector (1).
    Fig 2: Exhaust Temperature Sensor
    GC0146437Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    The exhaust gas temperature sensor requires care when handling and installing. The exhaust gas temperature sensor is sensitive to knocks and bending. For this reason if the exhaust gas temperature sensor has been dropped, it must not be installed as damage to the sensor may have occurred. Do not remove from packaging until ready to install. Failure to follow these instructions may result in damage to the exhaust gas temperature sensor.

  4. Remove the exhaust temperature sensor (1).
scientia non olet · About Mike's Workshop Manuals