Exhaust Temperature Sensor 1/1

Fig 1: Engine Cover

Courtesy of CHRYSLER GROUP, LLC

Disconnect the negative battery cable.
Remove the engine cover (1).

Fig 2: Cowl Extension Silencer, Side Extensions & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Remove the cowl extension (1) and the side extensions (2, 5). Refer to SILENCER, COWL EXTENSION, REMOVAL .

Fig 3: Two Nuts, Air Inlet Duct & Dash Panel
Courtesy of CHRYSLER GROUP, LLC
Remove nuts and the HVAC air inlet housing (1).

Fig 4: Oxygen Sensor Connector & Ball Stud Fastener
Courtesy of CHRYSLER GROUP, LLC
Disconnect the oxygen sensor wire harness connector (1).
Disconnect the upstream exhaust temperature sensor wire harness connector.

Fig 5: Diesel Particulate Filter Clamp
Courtesy of CHRYSLER GROUP, LLC
Loosen the clamp (2) and separate the Diesel Particulate Filter (DPF) from turbocharger.

Fig 6: Exhaust Manifold, Gaskets, Turbocharger, Cylinder Head & Fasteners
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
The exhaust gas temperature sensor requires care when handling and installing. The exhaust gas temperature sensor is sensitive to knocks and bending. For this reason if the exhaust gas temperature sensor has been dropped, it must not be installed as damage to the sensor may have occurred. Do not remove from packaging until ready to install. Failure to follow these instructions may result in damage to the exhaust gas temperature sensor.
Remove the exhaust temperature sensor (7).