Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2013 >> Grand Cherokee Laredo, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Accessories Control Systems >> MOPAR Accessories >> Driving Convenience >> Instruction Sheet >> Remote Start >> PEM Module Programming

PEM Module Programming

NOTE:

Perform this procedure on vehicles equipped with "Key N Go" push button ignition.

NOTE:

The wiTECH software level must be at the latest release to perform this procedure.

CAUTION:

Read all notes and cautions for programming procedures.

  1. Connect a battery charger to the vehicle.
  2. With the wiTECH diagnostic application, perform the following steps:
scientia non olet · About Mike's Workshop Manuals