Back Pressure Transducer: Installation: Installation

Fig 1: Identifying Sealing Washer & EGR Back Pressure Transducer

Courtesy of CHRYSLER GROUP, LLC

1. Using a new sealing washer (1), install the EGR back pressure transducer (2). Tighten transducer (2) to 25 N.m (18 ft. lbs.).
   Fig 2: Identifying EGR Back Pressure Transducer Harness Connector

   Courtesy of CHRYSLER GROUP, LLC
2. Connect the EGR back pressure transducer wire harness connector (1).
   Fig 3: Engine Cover

   Courtesy of CHRYSLER GROUP, LLC
3. Install the engine cover (1).
4. Connect the negative battery cable.