Unit, ELECTROHYDRAULIC Control: Installation: Installation

Fig 1: Connect The Selector Valve To The Detent Plate

Courtesy of CHRYSLER GROUP, LLC

1 - SELECTOR VALVE

2 - DETENT PLATE

1. Position the electrohydraulic unit in the transmission housing.
2. Insert selector valve (1) in driver of detent plate (2). Refer to Fig 1. When installing the electrohydraulic control module in the transmission housing, the plastic part of the selector valve (1) must engage in the driver of the detent plate (2).
   Fig 2: Removing/Installing Electrohydraulic Unit

   Courtesy of CHRYSLER GROUP, LLC

   1 - HEAT SHIELD

   2 - ELECTROHYDRAULIC UNIT

   3 - BOLT

   4 - OIL FILTER

   5 - OIL PAN

   6 - CLAMPING ELEMENT

   7 - BOLT

   8 - 13-PIN PLUG CONNECTOR

   9 - BOLT

   10 - ADAPTER PLUG

3. Install the Torx® socket bolts (3) and torque to 8 N.m (71 in.lbs.). Refer to Fig 2
4. Install a new oil filter (4). Refer to Fig 2.
5. Install oil pan (5) and torque the oil pan bolts to 8 N.m (71 in. lbs.). Refer to Fig 2.
6. Install the adapter plug (10) into the transmission housing and tighten the bolt (9) to 2. 5 N.m (22 in.lbs.). Refer to Fig 2
   Fig 3: Removing/Installing Wiring Connector Plug

   Courtesy of CHRYSLER GROUP, LLC

   1 - PLUG CONNECTOR

   2 - ADAPTER PLUG

7. Check O-ring on plug connector (1), and replace if necessary. Refer to Fig 3.
8. Install the plug connector (1) into the adapter plug (2). Turn bayonet lock of adapter plug (2) clockwise to connect plug connector (1).
9. Fill the transmission with the correct oil using the standard procedure. Refer to CAPACITIES AND RECOMMENDED FLUIDS, DESCRIPTION or FLUID AND FILTER, STANDARD PROCEDURE .