Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Jeep >> 2012 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Fuel System) >> Fuel Injection, Diesel >> Sensor, Intake Air Pressure >> Installation >> Installation

Sensor, Intake Air Pressure: Installation: Installation

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Cleaner Cover, Mass Airflow Sensor, Inlet Pressure Sensor & Electrical Connectors
GC0131128Courtesy of CHRYSLER GROUP, LLC
  1. Check condition of sensor O-ring.
  2. Install the Intake Air Pressure (IAP) sensor (5) and securely tighten fasteners.
  3. Install IAP sensor wire harness connector (4).
  4. Connect the negative battery cable.
scientia non olet · About Mike's Workshop Manuals