Damper, Vibration: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Installing Vibration Damper Onto Crankshaft Using Special Tool

Courtesy of CHRYSLER GROUP, LLC

Using (special tool #10387, Installer, Vibration Damper). Install the threaded rod (1) into the face of the crankshaft (3) till the face of the rod (4) bottoms out.

Fig 2: Installing Vibration Damper
Courtesy of CHRYSLER GROUP, LLC
Position the vibration damper (2) on the crankshaft.
Using Damper Installer (1) and a deep well socket, press the damper onto the crankshaft till seated.

Fig 3: Installing Vibration Damper
Courtesy of CHRYSLER GROUP, LLC
Install the vibration damper bolt.
Position the (special tool #10386, Holder, Vibration Damper) (2), onto the vibration damper (3).
Tighten the bolt to 250 N.m (184 ft. lbs.).

Fig 4: Cooling Fan Motor Assembly
Courtesy of CHRYSLER GROUP, LLC
Install the cooling fan module. Refer to FAN, COOLING, INSTALLATION .

Fig 5: Accessory Drive Belt, Tensioner & Pulleys
Courtesy of CHRYSLER GROUP, LLC
Install serpentine belt (1). Refer to BELT, SERPENTINE, INSTALLATION .

Fig 6: Upper Radiator Hose, Clamp, Oil Cooler Return Line Hose & Clamp
Courtesy of CHRYSLER GROUP, LLC
Position the upper radiator hose and secure retainer at the fan shroud.
Install the upper radiator hose at the thermostat housing and secure hose clamp (1).

Fig 7: Intake Air Temperature (IAT) Sensor, Air Cleaner Housing & Duct
Courtesy of CHRYSLER GROUP, LLC
Connect the air duct (4) at the throttle body and tighten clamp to 5 N.m (44 in. lbs.).
Connect the air duct at the air cleaner housing and tighten clamp to 5 N.m (44 in. lbs.).
Connect the electrical connector at the Intake Air Temperature (IAT) sensor (4).
Refill the cooling system. Refer to STANDARD PROCEDURE .
Connect the negative battery cable.